| << Previous - Next >> |
|
 |
Engine Case Hardware Kit Type-1Engine Case Hardware Kit Type-1 Article code: GPPCSP198 033 113
This hardware kit should be purchased together with every new Type-1 engine case. It is necessary to complete the engine case and to make it fit the different configurations, depending on which air-cooled car the motor is build for.
Parts contained according to the spare parts catalogue:
•1 sleeve for oil cooler mounting
•1 gasket for Type-3 pick-up tube
•1 CSP Products stainles steel block off plate for Type-3 pick-up tube
•2 CSP Products pistons for oil pressure and oil pressure relief valve
•1 spring for oil pressure relief valve
•1 spring for oil pressure valve
•2 CSP Products plug screws for oil pressure and oil pressure relief valve for 8 mm hexagon wrench
•2 O-rings for plug screws for oil pressure and oil pressure relief valve
•2 hexnuts M8
•2 spring washers M8
•4 studs for oil pump 21/26 mm
•2 studs for fuel pump
•1 stud for oil cooler M8
•1 stud for oil cooler M8/M6
•2 studs for engine case (not w/ Bus 091 gearbox)
Additional pieces in this hardware kit:
•4 studs for oil pump 30 mm
•2 studs engine case long (for Bus 091 gearbox)
€ 72.00
|
